Installation steps
- Take a photograph of your existing wiring harness for reference
- Remove existing wiring harness
- Remove the Nashville 3 Pickup Wiring harness from the card, and move it to the control plate of your guitar. Keep the wires in the card.
- Tighten the nuts and screws into place, securing the harness to the plate.
- Using a soldering iron, remove the "Out" guide wire from the card, replacing it with the wiring to your guitars jack
- Repeat step three for each of the pickups, connecting them to the corresponding switch
Product Specs
Switch: Oak Grigsby
Tone and Volume Pot: CTS
Blend Pot: Proprietary Blend Pot
